mx10-8-119-220 Help

Use the Privacy Mode, if you would like to deactivate the whole system, i.e. recording and any kind of camera access is rendered impossible until you deactivate this mode. While this lock can be deactivated directly from this computer, you will need the user name and password set in this dialog to deactivate the lock from a different computer. Note that the cameras are also signaling this operating mode by a specific LED blinking pattern.

Activating the "Privacy Mode"

To activate this mode, enter a user name and password, then click on the Set button.

Caution

This mode becomes effective immediately after you click on the Set button. If you would like to access the camera again, you need to use the access data you defined when activating the Privacy Mode.

Effects Of The "Privacy Mode"

The camera only accepts the access data (user name and password) you defined in the Privacy Mode dialog. Without these access data, you cannot deactivate the Privacy Mode any more.
The camera's entire image generation process is deactivated.
Recording is deactivated completely.
The camera's audio channel is switched off.
The camera shows a distinctive blinking pattern so you can see that the cameras are in this mode (see below).

Signaling by the Camera LEDs

The different MOBOTIX cameras are displaying the following blinking patterns once they have been switched to Privacy Mode:

Camera Type	LEDs	Blinking Pattern
Cameras with four LEDs		LED 0 flashes red every 3 seconds LED 3 flashes red every 3 seconds, in sync with LED 0
Cameras with two LEDs		LED 0 flashes green every 3 seconds LED 1 flashes green every 3 seconds, in sync with LED 0

Camera Type

LEDs

Blinking Pattern

Cameras with four LEDs

LED 0 flashes red every 3 seconds

LED 3 flashes red every 3 seconds, in sync with LED 0

Cameras with two LEDs

LED 0 flashes green every 3 seconds

LED 1 flashes green every 3 seconds, in sync with LED 0

Deactivating the Privacy Mode

Proceed as follows to deactivate the Privacy Mode:

Start a browser, enter the IP address of the camera and enter the access data you defined before.
Open the Privacy Mode dialog (http://<camera IP address>/admin/privacymode).
Click on the Set button to deactivate the Privacy Mode.

Description of Parameters

Parameter	Description
User Name	The user name for accessing the camera if the Privacy Mode is active.
Password	The password for accessing the camera if the Privacy Mode is active.